Can i retrieve gps data through the micro usb port in U blox m8n?

I want to know whether is it possible to get gps data through the micro usb port in U blox m8n gps module?

M8N is the GNSS UBLOX M8 receiver series from 2015, please use the older U-Center software to ensure configuration compatibility.

By default, the u-blox GPS module has the most common NMEA datasets enabled, like GNGGA, GNGSA, GNGLL,… Sometimes it is necessary to enable or disable specific NMEA datasets. To enable or disable specific NMEA datasets, follow the steps below.

Solution

  1. Open u-center.
  2. Connect to GPS module (default port is COM3, baudrate 9600).
  3. Go to View > Configuration View .
  4. Click MSG (Messages) on the left side list.
  5. For Enabling:
    Choose an NMEA dataset at Message . Check the boxes I2C , UART1 , USB, and SPI and enter 1 in all four On fields.
    u-blox settings in windows
    Click the Send button in the lower-left corner.
    u-blox settings in windows
  6. For Disabling:
    Choose an NMEA dataset at Message . Uncheck all the boxes.
    u-blox settings in windows
    Click the Send button in the lower-left corner.
    u-blox settings in windows
  7. Switch to CFG (configuration) tab in left side list. Select Save current configuration. At Devices, select all 4 list entries. (To select all entries, tap and hold pen/mouse on first entry and move down to last entry. Release pen/mouse). Click the Send button in the lower-left corner:
  8. Click Receiver > Action > Save Config :
  9. Done.