Ms5611

Hi ,

Do you have the schematics of the breadboard MS5611 ?

Thanks.

BR,
Stephane

Hello,

Maybe I can help you about the board!? What do you want to know please?

Hi,

I would like to know if there are PU resistors connected to the I2S wires.
The schematic should answer to my question :smiley:

Best Regards,
Stef

There are pull ups resistors on I2C bus. You can enable them with the solder bridge on the top of the board.

I worked with this module it’s very pwoerful ! :stuck_out_tongue:

Hi…i am new here. By profession i am a hardware design engineer. As per my knowledge it is right that there are pull ups resistors on I2C bus. You can enable them with the solder bridge on the top of the board. It is difficult to get the schematic of the board. So try to trace it from board only.