NTRIP client info save

Hello.
I am using the SIRIUS as a rover.
We are behind the GIS4Mobile app, and we want to use the SIRIUS in RTK mode.
Can I use u-center to set the ntrip client info, and make the SIRIUS remember this?
Or should we set it from our app, and what are the commands we need to send to the SIRIUS?

Hi there,

I have attached a link showing how to configure the rover as an NTRIP client.

https://drotek.gitbook.io/rtk-f9p-positioning-solutions/tutorials/setup-rtk-solution-using-a-local-network.

I hope this helps.

Thank you and have a nice day.

Hello.

Thank you but…

You also use u-center to set the ntrip client mount point.
I did that, and i observed the lamp on the sirius go green, vonderful.

But once I close u-center the green lamp goes out. Why is that? Does it require u-center to run?

Hi there,

Yes, it requires u-center or any other software such as Mission Planner connected to constantly send the RTCM data to the receiver.

You may also check the link for more ideas on how to proceed to achieve your goal.

I hope this helps.

Thank you for your patience and have a nice day.