PMU Pro configuration on Mission Planner

Hi every body,

Is there any tutorial for PMU Pro configuration on mission planner ? I’m using Pixhawk 2.1 Cube with PMU Pro with two parallel 6s 22000mAh LiPo. What should I choose in Monitor and Sensor section ?



Hi STab,
I purchased the PMU and a Drotek Pixhawk 3 Pro in March this year and since then I’m trying to get help/information to be able and see the voltage/amp draw in Mission Planner. So far no luck. I went through the Drotek support and they told me about some settings in PX4/QGroundControl, but this is not what I’m looking for. As well I tried to the ArduPilot/Mission Planner forums to get help or even an addition to Mission Planner so the PMU could finally selected as voltage/current “sensor”, but so far nothing as well. At least I found someone with the same problem. Hope in the near future there is some information to share.



Any luck?
My posts: Power Management Unit PRO