Power Module no connector

Dear community,

I have purchased a power module from this link: Voltage & current & 5.3V power supply - Mounted


But different from the usual power module that I used previously, this one doesn’t have the connector that can be connected to Battery. So does it mean I have to solder a connector on the cable ?

Based on your picture, the battery connector is the one on the left (XT60 Male connector)

There is no need to solder any connector, except a Female XT60 connector onto your battery pack.

The JST-GH 6 pins connector, must then be connected to your autopilot

Thank you for your help Paul. But the cables on the left side only have the 12 AWG wires without the connector. So how can I connect it with the ESC without soldering another connector on the 12 AWG wire ?