Problem with load receiver configuration

hello
I try to follow this tutorial to set my ZED-F9P in base mode.
[ZED-F9P RTK configuration - RTK F9P Positioning Solutions]

Anyway I use U center 21.09 and I have lots of option when I click on receiver configuration that it is not well explained on the tutorial …
I try following that to transfer the downloaded file to GNSS but I have an error because version does not correspond to the version of GPS receiver…

Is there a way to configure properly FP9 in base and in rover mode? File was a good idea but seems not work properly today…

image

image

1 Like

Hi there,

You may the follow the tutorial to load the (base) configuration file on to the F9P modules. Ensure that you select ‘‘Transfer file → GNSS’’ to load the configuration on ‘‘Receiver Configuration’’ interface.
Once you receive the above message ‘‘Configuration Version Check’’, you can still proceed by selecting ‘‘Yes’’. It simply indicates that the firmware version of the GPS module is updated to HPG1.13 and it would continue to use the HPG 1.11 file to the latest firmware. It is acceptable.
Can you try this please?
Thank you.

1 Like